

wasnt the whole point to be able to solder one yourself?
Scotch as in the tape, not the whisky


wasnt the whole point to be able to solder one yourself?


founder is a bit hard to bear sometimes. He banned me from all channels over a the tiniest little argument and so I can’t interact with and get any support from the community
i have seen the harsh takes on the valetudo website but thought it was a joke, what happened to deserve that


I’m just a little disgruntled because I like treating my Pi’s as headless servers, often with a single purpose, and I don’t want to have to erase the SD cards to upgrade versions.
sounds like a dietpi usecase! (sorry for the shilling, i just really like the project)
but hey, if debian works don’t touch it


I kinda understood half of the things you said, but i run DietPi on mine.
It has 64-bit support, you can update the os without resetting everything, still based on the original kernels for the closed source optimizations, but removes all the clunky and slow parts, leaving a very lightweight and fast os.
Plus, for newbies (like me) it has a decent built-in installer for various software with minimal ulterior setup required.


So they make the internet worse for poor people? I could get through 20k in a second, but someone with just an old laptop would take a few minutes, no?
i mean, kinda? you are absolutely right that someone with an old pc might need to wait a few extra seconds, but the speed is ultimately throttled by the browser


adding to this, some sites set the difficulty way higher then others, nerdvpn’s invidious and redlib instances take about 5 seconds and some ~20k hashes, while privacyredirect’s inatances are almost instant with less then 50 hashes each time




1L is 1dm³ (10cm³)
They aren’t “official” SI units but i’d much rather see liters then teaspoons


you may like publicdomainrecipes.com, a no-bs recipe website (doesnt have a lot of stuff, but you need to start somewhere)


same thing, one cubic centimeter is one ml
aaand next time they’ll leave their cell phone home to not get tracked, so not only do you not get their location, they can’t even call you in an emergency
good parenting, i guess
Knowing that mum or dad might go through their phone to check things makes them think about what they are doing spend 5 minutes researching how to hide stuff. Better to rely on trust then on pure force alone
Because it uses DoH and not DoT.
other way around, but yes


chaotic good, if I misremember the command lawful evil


Life’s tough for everyone
-Grandpa


cups, glasses, bowls, anything that doesn’t have a spout and makes a mess every time you transfer liquids
Every time I spill something I’m reminded how much better lab glassware is (beakers etc)


Removed by mod


Removed by mod


and Anarchist, in the case of Hexbear
more like right wing trolls
Damn, made me chuckle
Anyways, going by
When you press the solder against the iron’s tip, it should get wicked by the tip, and remain there until you press it on some wire/component leads.
If the solder beads up and slips away from the iron, or beads up and forms a blob at the end of the solder wire, it’s oxidised and you probably need to get a new tip. It needs to be shiny and metallic.
The tip needs to be regularely cleaned while soldering by brushing it on a wet sponge, and never let the iron cool down without some solder on the tip to prevent oxidation.
also, FLUX FLUX FLUX